Majority of print quality problems are related to parts of the drum unit. The steps below included directions for both replacement procedures. Do not let metal objects touch the development sleeve. Drum unit [A] and Development Unit [B] 8. Several suppliers provide PM kits to reconstruct the drum units however with the price of these appearing somewhat economical, I would personally lean in the direction of actually replacing unit as it takes minor technical expertise as opposed to rejuvenating it which can often become tricky and dirty. Otherwise, the hopper cover may be damaged. Turn the machine power on.

Uploader: Zushakar
Date Added: 13 August 2012
File Size: 42.48 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 12657
Price: Free* [*Free Regsitration Required]

Open the drum positioning plate [D]. Entering SP Mode 1.

Reattach the hopper cover hook x 3. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first and use them for reassembling the new drum unit and development unit.

Commonly when you begin noticing color streaks or color back grounding it can be a indication that the charge grid and cleaning blade are starting to go bad.

Last Drivers  DWL 2100AP DRIVERS

Make sure that the harness [A] is hooked as shown. Enter the Service Mode. You must be logged in to post a comment. Remove the bushing [A] of the development roller at the rear of the PCU 6.

Ship a Savin – C3333

Otherwise, the hopper cover may be damaged. The new drum unit has a front cover and a front joint. The hook breaks easily. Leave a Reply Cancel reply You must be logged in to post a comment.

Follow the correct order. Drum unit [A] and Development Unit [B] 8. The bearing is properly applied with lubricant. Do not touch the OPC drum. Hopper cover [A] 4 hooks Release the three hooks first in the correct order Put the head of a screwdriver in the groove gap [B] as shown, swvin then release the hook.

When the development unit is removed from the svin unit, clean the entrance mylar [C] with a vacuum. Keep the developer off at both ends of the development unit enclosed in red lines in the diagram.

Rotate the development roller [A] five or six times in the counterclockwise direction. Remove it with a flat screwdriver. If you change the development unit, do the ACC procedure. Front cover [A] Do not touch the bearing [A] after removing the front cover. Do the ACC procedure. Shake a bag of developer and pour it into the development hopper [A].


Savin c Copier Parts Copier Parts Supply Sale

Do not let metal objects touch the development sleeve. Pull out the PCU hold the grip while you pull it out. Turn the machine power off.

This savim removes developer that has stuck to the development roller, which would cause color unevenness. Lever lock [A] 3.

Savin C Staple Cartridge 3Pack (Type K) 5, Staples Ea.

Open the front door. Turn the drum positioning plate lever [B] and the image transfer unit lock lever [C] counter-clockwise. Remove the front joint [A] The front joint [D] is firmly set.

Turn the machine power on. Execute the drum phase adjustment with SP twice.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top